The Singapore Infocomm Media Development Authority (IMDA) has recently updated the Technical Specifications of Short-Range Devices (SRD) resulting in several changes, including below ones:
![](/userfiles/image/Singapore%20SRD%20(NEW).png)
For more information, please refer to the TS SRD document available via this link:
www.imda.gov.sg/-/media/imda/files/regulation-licensing-and-consultations/ict-standards/telecommunication-standards/radio-comms/imdatssrd.pdf
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
11-24-2021
Singapore Infocomm Media Development Authority (IMDA) updated the Technical Specifications of Short-Range Devices (SRD).
Recently Singapore IMDA updated the Technical Specifications of Short-Range Devices (SRD). As a result, SRDs are re-organized, categorized, and the technical requirements amended, which includes the below changes listed out that clients may concern most about:
1. ' Wireless power transfer ' based on EN 303 417 is allowed in 16 – 150 kHz; 150-5000kHz; 6765-6795kHz
2. ' Intermittent/Periodic transmission of control signals ' based on FCC Part 15 §15.231and ANSI C63.10-2013 is allowed in 433.05 – 434.79 MHz and 312.00 – 316.00 MHz
3. 920 – 925 MHz is additionally allowed for LPWAN, RFID, and ' Non-specific SRD '
4. "Automotive radars" based on EN 302 858 is allowed to 24.00 – 24.25 GHz.
5. 57 - 64 GHz is additionally allowed for ' Non-specific SRD '
6. Both indoor and outdoor applications of WLAN in 57 - 66 GHz apply to the sametechnical requirements.
7. The allowed frequency band for SRD in 5.8GHz is extended from '5.725 – 5.850 GHz to'5.725 – 5.875 GHz.
8. The allowed output power for radio-determination devices in 2.400 – 2.4835 GHz isreduced from 100mW to 25mW.
Additionally, the following AV/ICT equipment shall comply with the IEC 62368-1 (minimum Ed. No. 2) standard:
(a) Equipment designed for use with a voltage rating between 50V and 1000V for AC orbetween 75 V and 1500V for DC;and/or
(b) Mobile/wearable devices which operate within the SRD frequency(s) such as tabletsand mobile phones.
The official link is as below:
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
07-10-2017
IMDA of Singapore updated Technical Specification for Celular Mobile Terminal which came into effect on July 1, 2017.
Singapore Authority Info-communications Media Development Authority (IMDA) updated Technical Specification (TS) for Cellular Mobile Terminal (CMT) which came into effect on July 1, 2017.
Main changes in this update TS include:
(1) Support LTE-Advanced TDD RIT (E-UTRA RAT)
(2) Use of E-UTRA Band 38 and Band 40
(3) CMT safety testing to be performed to the IEC 60950-1 safety standard
For more information, please feel free to contact us.
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
10-28-2016
Singapore IMDA published transitional arrangement for labeling of registered telecommunication equipment.
Following our previous news dated October 11 about the newly formed Singaporean telecommunication Authority IMDA, please be informed that IMDA recently updated the labelling requirements, in which specifies the transitional arrangement for labeling of registered telecommunication equipment:
• Under Section 91(1) of the Info-communications Media Development Authority Act 2016, which came into force on 1 October 2016, all dealer’s licences and equipment registrations previously issued by IDA before 1 October 2016, will remain in force and will be deemed to be issued by IMDA. All conditions in the respective dealer’s licence and equipment registration will remain the same.
• Equipment that has been registered or renewed before 1 October 2016 with existing stock that are already affixed with the IDA compliance label before 1 October 2016, need not be replaced with the new IMDA compliance label.
• Equipment that has been registered or renewed after 1 October 2016 with IMDA, shall be affixed with the IMDA compliance label by no later than 30 September 2017. This is to allow time for dealers to prepare and affix the new IMDA label.
If you have any question, please feel free to contact us.
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
05-15-2012
Ellectronic compliance labels on registered telecommunication equipment are allowed from April 4, 2012
The Infocomm Development Authority of Singapore (IDA) revised “Requirements for Telecommunication Equipment Labels and Advertisements” on April 4. Based on the latest version of this regulation, the use of electronic compliance labels on registered telecommunication equipment is allowed from now on.
Telecommunication equipment dealers licensed by IDA, such as suppliers or manufacturers, are permitted to display the compliance label on the equipment's built-in display screen or in the softcopy of the equipment's instruction manual, as an alternative to traditional sticker labels. Licensees will have to provide an instruction guide or leaflet in the equipment packaging to inform consumers about where to locate the electronic compliance label for verification.
If licensees choose to use traditional sticker label, the label should be affixed on the registered telecommunication equipment itself, or on the equipment's instruction manual or packaging, before such equipment is displayed or offered for sale for use in Singapore.
For more information, please kindly contact WoWi Approval Services, Inc.
.
|